- info@chinapeanutmachinery.com
+0086 372 5388851
+0086 372 5388851
The peanut sheller and cleaning machine has three parts: the first part is peanut cleaning machine, used for removing stones and impurities in the peanuts; the second part is the peanut conveyor, use to transmit peanuts to the peanut sheller after cleaning and the third part is peanut sheller machine for the peanut shelling.
Capacity: 3500kgKG/H
Powder:2*7.5kw
Shelling Ratio: >=98%
Crushing Ratio: <=4%
Packing:3010*1360*2820mm
There are many things need to pay attention when using any machine tool. Unnecessary accident is inevitable if being used improperly. During the shelling process, there are a lot to be noticed when using the peanut sheller machine, the following are the main points:
1. Close the telescopic hopper before feeding. After the hopper is full of peanut fruits, open the gate slowly and close the outlet gate at the same time. When the peanut kernels and small fruit are gathering in gravity separation sieve for about 20 to 30mm, then open the gate slowly so that peanut kernels can flow out smoothly and small fruit would be left. In the production process, the kernel gate should be adjusted to the appropriate place, otherwise it will increase the breakage rate and reduce the cleaning degree.
2. When in the use of the peanut sheller machine, if the discharging gate is open, but the peanuts can not be discharged, you can adjust the connecting rod screw to the long direction, then the peanuts can be smoothly discharged.
3. If too many peanut kernels are found in the shells when using peanut sheller machine, you should reduce the air inlet of the fan. If there are too much shells in the feed inlet, you need to increase the air inlet of the fan appropriately.
4. When the peanut sheller machine works, the gravity sieve should be placed horizontally to make the impurity rate of peanuts from the outlet meet the requirement.